This is the Photon Speed 2 Motor (20 turn, single wind) from Duratrax.
This is the stock motor found on the Duratrax Evader EXT.
FEATURES: Great for monster trucks
Closed endbell, not rebuildable
Standard (not laydown) brushes
INCLUDES: One motor
Two pre-installed capacitors
Pre installed bullet-type motor leads
REQUIRES: Two 3mm mounting screws
Bullet-type leads for speed control
SPECS: Turns: 20
Stock for 7.2-8.4 volt battery
Uses oilless type brushes
Shaft Diameter: 3mm
Shaft Length: 12mm
Overall Length: 68mm
Outside Diameter: 36mm
For proper break-in, use a 3-5V power source, run the motor with
no load. The contact patch should take up at least half of each
brush's surface. Do NOT use more than 5V power, as the
commutator may be damaged.
updt jxs 4/21/09