This is a Glow Plug Igniter with Cap Meter and AC Charger from HPI Racing.
     The glow starter is used to heat a glow plug while starting an engine.

FEATURES: Hot pink machined and knurled aluminum battery holder.
          NiCd cell provides higher voltage under a load than an alkaline cell.
          Meter has green area for charged and red area for must recharge.
          Spring-loaded locking socket design.
          Comes on a picture instruction header card.

INCLUDES: One Glow Starter with Cap Volt Meter.
          One Panasonic 1.2volt, 1300mAh sub-C size NiCd Battery
          One AC Charger (United States Standard)

REQUIRES: Charging of NiCd battery for ten hours before use.

SPECS:    Adaptor Input: AC 120V~60Hz 2W (United States Standard)
          Adaptor Output: DC 1.25V at 170mA
          Shaft Length: 2-1/4" (57mm)

COMMENTS: Battery for this glow-starter can be replaced with another sub-C
            type battery by unscrewing the battery holder.
                                                                   dew 11/18/00
                                                                          ir/jl