FlightPower EONX Rx LiPo 2S 7.4V 1600mAh

Tower Stock# LXWTX6  •  Manufacturer Stock# FPEONXRX16002S
FlightPower EONX Rx LiPo 2S 7.4V 1600mAh (large view)
Tech Notices:Notice 1
Shipping Restricted ItemDetails
Shipping Note:Details
Product WarningDetails
Notes from our tech department:
This is the FlightPower EON-X RX 1600 2S 7.4V
LiPo Receiver Battery Pack with Balance Connector from FlightPower.

FEATURES

Provides unequalled voltage stability and lighter weight than stock
receiver batteries
Ideal for the latest high torque, high speed servos that require more
current
Pre-fitted with two universal radio connectors, one for plugging
into a regulator and one for charging at rates of up to 2.5C with
an approved balancer such as the Great Planes ElectriFly Equinox
LiPo Balancer

INCLUDES

FlightPower EON-X RX 1600 2S 7.4V LiPo Receiver Battery Pack, two
universal radio connectors, FlightPower balance connector and
instruction sheet

REQUIREMENTS

ElectriFly Equinox LiPo Balancer, GPMM3160 and 2S Adapter
if using this balancer
Charger - TRITON2

SPECIFICATIONS

Size: 2.72 x 1.62 x 0.55" (69 x 42 x 14mm)
Weight: 3.0oz (85g)
Capacity: 1600mAh
Rated Voltage: 7.4V
Number of Cells in Series: 2
Max. Charge Voltage: 4.25V per cell
Min. Discharge Voltage: 3.0V per cell
Maximum Recommended Charge Current: 2.5C

COMMENTS

ALWAYS use a LiPo-approved charger. DO NOT use wall charger supplied
with radio
ALWAYS use a LiPo Cell Balancer
ALWAYS read enclosed instruction sheet
NEVER Charge over 4.25V per cell
NEVER Charge at currents greater than 2.5C with balancer
NEVER Charge through the "To ESC or "DISCHARGE" lead
NEVER Trickle Charge
NEVER charge dissimilar or unmatched packs in series or with any
difference in cell type, cell capacity, pack capacity or charge
state (0.03V per cell) if in doubt, charge separately
NEVER allow to Discharge below 3.0V per cell
Never expose pack to intense heat or prolonged exposure to elevated
temperature
NEVER continue charging if any part of pack gets warm (LiPo packs
should not heat up during charging)
NEVER charge a pack at sub-zero temperatures
NEVER disassemble or modify pack wiring in any way or puncture cells
NEVER place on combustible materials or leave unattended during
Charging
NEVER charge a pack that is under voltage after recovery (under 3.0V
per series cell)
ALWAYS Charge in a fireproof location
ALWAYS set charger's output volts to match battery volts
ALWAYS keep out of reach of children

jxs 01/21/10
ir/jxs

Resources
‐ Mailing Address ‐
‐ Additional Contact Information ‐