Cars & Trucks > Car & Truck R/C - Nitro-Powered > Car & Truck R/C Kits Nitro-Powered - Off-Road -.16 & Up Bookmark this Page

Hot Bodies - HBSC6780 HBS67800 67800 944258678009 4944258678009
Manufacturer Stock#
67800
A Closer Look at This Product
  Tech Notes

Accessories Needed

Possible Substitutions

Replacement & Optional Parts

Easy RC: Cars & Trucks

Browse Hot Bodies

Product Feature Page


Hot Bodies 1/8 D8T Nitro Truggy Kit
 
Click for parts for this item
Hot Bodies 1/8 D8T Nitro Truggy Kit
View Larger Picture


 
Stock Number
LXWWR4
Stock Status
Discontinued
Possible Substitutions
   
 

Tech Notes
 
NOTES FROM OUR TECH DEPARTMENT
This is the 1/8 scale, glow powered, radio controlled,
Hot Bodies off-road D8T Truggy Kit.

FEATURES

Chassis: 0.16" (4mm) thick 7075 aluminum with 10 of kickup,
composite chassis braces
Drive: Four wheel shaft drive
Fuel Tank: 5.1oz (150cc) plastic with flip top cap
Air Filter: Foam low profile design
Clutch: 3 shoe, carbon construction
Clutch Bell: 13 tooth steel
Transmission: Single speed
Ball Bearings: Full set
Shocks: Four oil-filled, 16mm Big Bore aluminum bodied
Main Gear: 50 tooth steel
Gearboxes: Sealed
Differentials: Planetary
Brakes: Dual fiber discs
Wheels: White plastic dish wheels, 3.7" (95mm) diameter, 2.3" (58mm)
wide, 17mm hex
Body: Clear untrimmed polycarbonate truggy body
Bumpers: Front hardened plastic
Suspension: Captured hinge pin design, extra wide pivot block for
optimized geometry
Caster: Adjustable, caster/toe-in refers to the angle of the front
suspension when viewed from the side of the car in relation to the
chassis
Camber: Adjustable, camber refers to the angle of the tops of the
tires from vertical when viewed from front or behind vehicle
Steering: Bell crank type with servo saver
Warranty Period: Two year limited, valid only in the U.S. Canada, and
South America

INCLUDES

1/8 scale Hot Bodies off-road Truggy Kit, foam air filter, body,
wheels, rear wing, clutch bell, spur gear, instructions and decal
sheet

REQUIREMENTS

Radio: 2-Channel with 2 Servos (one high torque servo for steering)
Radio Batteries: (8) AA size
Receiver Pack: 6V hump
Engine: .21 cu in (3.4cc) rear exhaust
Exhaust: Tuned pipe
Engine Starter: Hand-held type with rubber adapter for vehicle use
Tires: 1/8 scale off-road truggy
Glow Starter: 1.2 volt
Paint: Polycarbonate safe for body
Misc. Items: Fuel bottle, building and track equipment
Fuel: 2-cycle glow fuel with 10%-15% nitromethane, 16% lubricant-
Most of the fuels we carry meet or exceed the lubricant content
required for optimum performance and maximum engine life. In the
past, the conventional lubricant content used in fuel was 18%. But
with new advanced technologies, fuels like Red Alert and O'Donnell
for example, have a better quality of lubricants even though the
percentages of lubricant content are lower. These high-tech
lubricants provide exceptional cooling and protection.

SPECIFICATIONS

Vehicle-
Length: 21" (530mm) from front bumper to end of rear wing
Width: 15.9" (405mm)
Weight: 9lbs (4082g) approximately
Wheelbase: 15-15.1" (380.5-383.5mm) wheels on-center front-to-rear
Gear Ratio: 4.3:1
Body-
Length: 18.2" (462mm)
Width: 7.4" (188mm) at middle section (widest point)
6.9" (175mm) ahead of front wheels (thinnest point)
Height: 4.1" (105mm)

COMMENTS

For Replacement Ball Bearings use:
Qty. Size Location Qty. Bearing Set
2 6x10mm Steering 1 DTXC1561
6 8x16mm Diffs 3 DTXC1585
2 5x11mm Clutch 1 DTXC1547
4 8x14mm Front Hubs 2 DTXC1583
4 8x14mm Rear Hubs 2 DTXC1583

jxs 3/13/09
ir/jxs

– If you need more information, use these Hot Bodies resources –
Email: support@hpiracing.com
Web Site: http://www.hotbodiesonline.net/
Phone: 888-349-4474
  Postal Address:
Hot Bodies
3002 N. APOLLO DRIVE, SUITE #1
CHAMPAIGN, IL 61822

Click here for Units of Measure Conversion Calculators

Accessories Needed
 
COMPLETION NOTES FROM THE TECH DEPARTMENT
This is the glow powered, radio controlled Hot Bodies Off-Road Truggy Kit. FEATURES: 0.16" (4mm) 7075 aluminum chassis, Big Bore shocks, 1-piece engine mount & radio tray, captured hinge pin suspension, CNC shock towers REQUIRES: 2-ch radio w/high torque steeering servo, RX battery, tires, fuel, fuel bottle, glow starter, building & track equipment

Accessories for the Hot Bodies 1/8 D8T Nitro Truggy Kit

Primary Accessories Radio & Engine Equipment Building & Field Equipment Optional Accessories
 
  Special Stock Number Product Description Parts Saver Eligible Tower's
Low Price
Click to Order Quantity Needed In Cart? Stock
Status
 LXUM80 Duratrax Glow Starter C Battery
Qty Discount Available
7.99   In Stock
 LXDHJE Duratrax Onyx AA Alkaline Battery (8)
Qty Discount Available
5.49   In Stock
 LXCMDL Fuji Batteries C Alkaline Battery (2)
Qty Discount Available
4.69   In Stock
 LXRXC9 Tower Hobbies TOWER Power 20% Car Fuel Quart
Qty Discount Available
10.69   In Stock
Subtotal for this Group of Accessories: 28.86  
Click to Order all items listed in this Group of Accessories    Buy This group of Accessories

Primary Accessories Radio & Engine Equipment Building & Field Equipment Optional Accessories

 
Tower Hobbies Has Been Serving Hobbyists Since 1971 • Call 800-637-6050 or 217-398-3636
See Tower Hobbies Reviews at Bizrate.com
Hobbico, Hobby & Model Construction Supplies - Retail, Champaign, IL
We accept the following: We accept the following payment methods: Discover, MasterCard, Visa, American Express, Diners Club International, JCB, China UnionPay, PayPal, and PayPal Credit.
Unauthorized use of any materials presented here is prohibited. Copying or reproducing any elements from this page is not permitted. All prices, descriptions and availability subject to change. Displayed within some areas of our web site, the Retail Price is suggested by the manufacturer or supplier, or estimated in keeping with standard industry practice. It may not represent the prevailing price in your area or a price that Tower Hobbies has ever offered for the item.
Copyright © Tower Hobbies All rights reserved. Do not duplicate or redistribute in any form.