This is the 1/8 scale glow powered, radio controlled,
               Associated Factory Team RC8 Off-Road Buggy kit.

FEATURES: Chassis: Milled 0.12" (3mm) hard-coated 7075 aluminum, one-piece top
            plate, molded composite front and rear braces
          Drive: Four shaft wheel drive, 3.5mm light CVA drivetrain, rear
            molded CVA boots
          Air Filter: Low profile elliptical high-flow two stage
          Fuel Tank: Anti-foaming, easily removed with two clips
          Clutch: Machined aluminum racing type, 16 tooth clutch bell
          Transmission: Assembled
          Ball Bearings: Full set included
          Shocks: Four oil-filled Factory Team Big Bore, threaded hard coated
            with 4mm TiN stainless steel shock shafts, Factory Team shock oil,
            steel alloy stand-offs
          Shock Towers: 7075 blue aluminum 0.20" (5mm) thick
          Spur Gear: 44 tooth, metal
          Gearboxes: Sealed, 4.3:1 ratio
          Differentials: Preassembled and filled with Factory Team diff fluid,
            split center diff mount for quick access to center diff
          Wheels: Factory Team 3.3" (83mm) diameter, 1.7" (42mm) wide white in
            color, 17mm hex
          Brakes: FFC Free Float Caliper system eliminates unwanted brake drag
            heatsink brake discs
          Body: Clear untrimmed buggy
          Bumpers: Front
          Radio Tray: Molded composite with optional forward placement battery
            box for increased steering
          Caster: Adjustable 14°,16°, or 18° with molded inserts, caster/toe-in
            refers to the angle of the front suspension when viewed from the
            side of the car in relation to the chassis
          Camber: Adjustable, camber refers to the angle of the tops of the
            tires from vertical when viewed from front or behind vehicle
          Suspension: Pre-assembled, 7075 blue aluminum mounts with inserts
            for easy adjustment of rear toe-in, rear anti-squat and front kick-
            up
          Steering: Bell crank type with servo saver and optimized geometry for
            more consistency and reduced bump-steer

INCLUDES: Associated Factory Team RC8 Buggy kit Factory Team shocks, fully
            adjustable wing, pre-assembled front and rear suspension, wheels,
            hard-coated threaded shocks with rubber boots, 44T spur gear, clear
            body, 16 tooth clutch bell, air filter, decals, instructions

REQUIRES: Radio: 2-Channel with 2 Servos
          Radio Batteries: (8) AA size
          Receiver Battery: 4.8-7.4V flat or hump NiMH or 1600-2100 LiPo pack
          Engine: .21 rear-exhaust
          Glow Starter: 1.2 volt
          Starter Box
          Tires: 1/8 scale buggy
          Paint: Lexan specific spray or brush-on
          Misc. Items: Fuel bottle, building and track equipment
          Fuel: 2-cycle glow fuel with 10%-15% nitromethane
            Most of the fuels we carry meet or exceed the lubricant content
            required for optimum performance and maximum engine life.  In the
            past, the conventional lubricant content used in fuel was 18%.  But
            with new advanced technologies, fuels like Red Alert and O'Donnell
            for example, have a better quality of lubricants even though the
            percentages of lubricant content are lower.  These high-tech
            lubricants provide exceptional cooling and protection.

SPECS:      Vehicle-
          Length:      18.5" (470mm)
          Width:       12"   (305mm)
          Height:       7.25" (184mm)
          Weight:       7.9 lbs (3570g) approx.
          Wheelbase:   12.7" (323mm) wheels on-center front-to-rear
          Track:       10.2" (259mm)
          Gear Ratio:   4.3:1
            Body-
          Length:      12.8" (325mm)
          Width:        8"   (204mm) at widest point
          Height:       3.6" (91mm)

COMMENTS: For Replacement Ball Bearings use:
            Qty.  Size      Location                  Qty. Bearing Set
             2    8x16mm    Front & Rear Diff          1   DTXC1585
             2    8x16mm    Center Diff                1   DTXC1585
             4    8x16mm    Front Hubs                 2   DTXC1585
             4    8x16mm    Rear Hubs                  2   DTXC1585
             4    6x10mm    Steering                   2   DTXC1561
             2    8x16mm    Front Bulkhead             1   DTXC1585
             2    8x16mm    Rear Bulkhead              1   DTXC1585
             4    15x21mm   Front Suspension           2   ASCC6862
             4    15x21mm   Rear Suspension            2   ASCC6862
             2    8x16mm    Rear gearbox               1   DTXC1585
             2    5x10mm    Clutch                     1   DTXC1535

                                                                    jxs 6/10/09
                                                                         ir/jxs