Novak M2 Dig 3S ESC/Dual Terra Claw Brushed Motors

Tower Stock# LXYRZ8  •  Manufacturer Stock# 1845
Novak M2 Dig 3S ESC/Dual Terra Claw Brushed Motors (large view)
Notes from our tech department:
This is the Novak M2 Dig 3S Electronic Speed Control
and two Terra Claw 55 Turn Brushed Motors.


M2 Dig 3S ESC;
Independently powers the front or rear motors in a dual-motor
crawler, applicable for dual brushed motor or single brushed
motor applications
Compatible with any Super Crawler dual-system rig, such as EnRoute's
Berg, Team Integy's Super and Unlimited class of crawlers and
Clod Buster based vehicles
Five adjustable parameters; Drag Brake, Dead Band, Minimum Drive,
Drive Frequency and Battery Selection (LiPo LiFe and NiMH)
Can be adjusted and fine tuned via Novak's PC interface, the Novalink
not included
Compatible with dual-brushed motor or single-brushed motor
Universal JST Input Plug fits all popular brand receivers
Water-resistant case with gasket seal
Terra Claw 55 Turn Brushed Motor;
High-strength ferrite magnet
Precise movement control and exceptional torque and long-run times
due to the high turn count
0.125" (3.2mm) shaft diameter fits all common pinion gears


Novak M2 Dig 3S Electronic Speed Control with receiver plug, power
wires, two Terra Claw 55 Turn Brushed Motors and instruction sheet


Installing in vehicle and connecting to battery and receiver


M2 Dig 3S ESC
Input Voltage: 2-3S LiPo/LiFe cells or 4-9 NiMH cells (1.2V/cell)
On-Resistance (dual motor): 0.0016 ohm at 25 C trans temp
On-Resistance (single motor): 0.0008 ohm at 25 C trans temp
Size: 1.16 x 1.47" (29.5 x 37.3mm)
Weight (w/o wires): 1.30oz (36.9g)
Motor Limit: 27-turn (2S), 33-turn (3S) 540-sized dual brushed motors
BEC: 6.0 volts DC/5.0 amps
Status LEDs: 4 on-board; 2 external
Voltage Cut-Off: 6.25V (2S LiPo), 4.75V (2S LiFe), 9.75V (3S LiPo)
7.125V (3S LiFe) (when LiPoly cut-off circuitry is enabled)
Power Wires: 14G super-flex copper-strand silicone wire
Terra Claw 55 Turn Brushed Motor
Size: 2.07 x 1.42" (52.7 x 36.1mm)
Shaft Diameter: 0.125" (3.2mm)
Motor Weight: 5.97oz (169g)
Input Voltage: 4-7 cells (1.2V/cell) or 2-35 LiPo/LiFe cells
Bearing: Standard, 3/8 x 1/8"
Magnet: High-strength ferrite
Number of Turns: 55

jxs 12/10/10

‐ Mailing Address ‐
‐ Additional Contact Information ‐