AeroWorks Extra 300 QB GP/EP ARF Orange .60-.90,60.5"

Tower Stock# LXZNP8  •  Manufacturer Stock# AEX300OB6090
AeroWorks Extra 300 QB GP/EP ARF Orange .60-.90,60.5
Notes from our tech department:
This is the radio controlled, glow or electric powered, almost-ready-to-fly
.60-.90 Extra 300 QB (Quick Build) Airplane from Aeroworks.
For Intermediate Sport or 3D Pilots.


Construction: Laser cut and jig built balsa and ply and glued
double-beveled control surfaces
Wings: Two-piece balsa and ply construction with pre-hinged ailerons
and carbon fiber wing tube
Aileron Control: One servo per wing
Rudder Control: Single servo pull-pull system
Engine Box: Plywood, installed and fuel proofed
Engine Mount: Two-piece composite
Cowl: Painted fiberglass
Covering: Ultracote, orange and blue color scheme
Canopy: Pre-mounted molded plastic
Landing Gear: Preformed carbon, steerable tailwheel, three foam
Fuel Tank: 15oz (450cc)
Spinner: White plastic 2.25" (57mm)
Wheel Pants: Painted fiberglass
Building Time: Ready to fly in approximately 8-10 hours
Warranty: Aeroworks manufacturing guarantees this kit to be free from
defects in both material and workmanship at the date of purchase.
This limited warranty does not cover any component parts damaged by
use or modification.


Pre-built and covered wings, fuselage and tail assemblies, pushrods,
all hardware, decals, throw meter, fuel tank, landing gear, wheels
wing tube, spinner and instruction manual on CD


Radio: 6-channel minimum computer radio with PCM receiver strongly
Aileron Servos: Two with at least 80 oz/in torque @ 4.8V
Rudder Servo: One with at least 80 oz/in torque @ 4.8V
Elevator Servo: One with at least 80 oz/in torque @ 4.8V
Servo Extensions: Four 6" One 12"
Receiver Battery: 4.8V 1100mAh minimum
Engine: .60 -.90 cu in (9.8 - 14.7cc) 2 or 4-stroke with standard or
Pitts muffler OR
Electric Motor: Aeroworks recommends the Skyshark Lightning 50
Power Package (not carried)
Propeller, building and field equipment


Wingspan: 60.5" (154cm)
Wing Area: 690 sq in (44.57 sq dm)
Fuse Length: 56" (142cm) Rudder to Front of Spinner
Weight: 6 - 6.5bs (2.72 - 2.94kg)
Center of Gravity: 2.5" (63mm) back from the leading edge of the
wing measured at the wing tip
Control Throws- 3D Rate High Rate Low Rate
Elevator up & down: 2.5" or 45 1.75" or 25 7/8" or 16
Rudder left to right: n/a or 40 n/a or 35 n/a or 20
Ailerons up & down: 2.25" or 35 1.5" or 25 1" or 16
Exponential: 15% on low rates, 30% on high rates, 60% on 3D rates


The decals shown in the photo is a Custom Decal Set that is not
included and must be ordered from Aeroworks.
Visit to order.

jxs 03/16/10
updt jxs 01/10/12

Know Before You Fly
Easy RC: Airplanes
‐ Mailing Address ‐
‐ Additional Contact Information ‐