Robart Left Hand Offset Pneumatic Tail Wheel

Tower Stock# LXET17  •  Manufacturer Stock# 160LWC
Robart Left Hand Offset Pneumatic Tail Wheel (large view)
Regularly Purchased Together
Although customers also purchased these, compatibility is not guaranteed. Click an item for product details.

Notes from our tech department:
This is a large scale retractable tailwheel with left-hand offset axle for the
tailwheel and air cylinder. For use with planes up to 40 lbs.

FEATURES

This Unit Comes Pre-Assembled with an Air Cylinder and Tailwheel
Axle Attached.
Steerable with a Pull-Pull System Attached to the Rudder Servo.

INCLUDES

One Retractable Tailwheel w/Air Cylinder & 3/16"Offset Tailwheel Axle
One Instruction/Parts List Sheet

REQUIREMENTS

Pressure Tubing to Reach from the Main Control Unit to the Air Ram
One 2" Tailwheel
Plastic Sleeved Pull-Pull Steel Steering Cables(Goes to Rudder Servo)
Four #6-32 Mounting Screws
Four #6-32 Blind Nuts
Four 3/8" x 1/2" Maple Mounting Blocks
Four Dowel Pins (Used to Mount Maple Mounting Blocks to Bulkhead)
Epoxy

SPECIFICATIONS

Retract Mounting Brace Height: 2-11/16" (68.5mm)
Retract Mounting Brace Width: 2"
Height from Axle Center to Bottom Retract Brace: 2-1/8" approx.
Extended Length from Axle Center to Retract Brace Mount: 3-11/16"
Retracted Length from Axle Center to Retract Brace Mount: 4-1/8"

COMMENTS

On the Air Cylinder: Extend Fitting is Located Forward and the
Retract Fitting is Located Aft.
For the Fork Axle Version, use ROBQ2230.
JAL 2/3/99
ir/jl

Resources
‐ Mailing Address ‐
‐ Additional Contact Information ‐