This is the C-12 Micro High Frequency Electronic Speed Control w/BEC.
For small to medium size electric aircraft with 400 size or
smaller Brushed Motors requiring 12A or less.
FEATURES: Extremely compact size to minimize weight and simplify installation
Set battery type with included jumper
"Safe-Start" system prevents accidental motor starts by disabling the
motor circuitry until the throttle stick is moved to full throttle,
then to the OFF position.
Factory installed motor, radio and battery connectors
Fully proportional forward only (no brake)
Battery Eliminator Circuitry provides sufficient current for the
receiver and three to four micro servos. The motor battery powers
the receiver and servos, then when voltage is reduced to the
appropriate level, the Low Voltage cut-off circuitry stops the
motor while continuing to supply power to the receiver and servos.
High frequency to optimize battery run-time and cool operation
Brilliant Blue LED and audible tones for easy set-up
Very smooth throttle response
180 day limited warranty
INCLUDES: One C-12 Micro Electronic Speed Control with Deans polarized micro
connector for battery, 2mm gold plated female bullet motor
connectors and Universal receiver connector
One instruction sheet
REQUIRES: Attaching to motor and setting up speed control
Battery pack
Plug Universal plug into the throttle channel on the receiver
SPECS: Length: .83" (21mm)
Height .31" (8mm)
Width: .43" (11mm)
Weight: .28 ounce (8g) with wires
Input: 6-8 NiCd/NiMH cells; 2-3 LiPo cells
Max Rated Current: 12A continuous
BEC Voltage: 5V/1A
Low Voltage Cutoff: .80V per cell for NiCd/NiMH
2.75V per cell for LiPo
Connectors: Receiver lead- Universal
Battery lead- Deans 2R micro connector
Motor connector- 2mm gold plated female bullet connectors
Switching Frequency: 2.5kHz
Motor Size: 400 or smaller Brushed only
COMMENTS: Will handle 4 micro servos with proper cooling
Do NOT use with Brushless motors
jxs 6/13/05
EEW 7/19/05
ir/jxs
Yes
