This is the 1/10 scale electric powered, radio controlled, on-road
  Intimidator SE Pro-Comp Racing Chassis Kit from Custom Works R/C Products.
   Includes all parts to build either a Dirt Modified (EDM) or a Latemodel.
              Recommended for modelers 16 years of age and older.

FEATURES: Chassis: 0.12" (3mm) thick carbon fiber, adjustable front and rear
            width
          Shock Towers: 0.12" (3mm) thick carbon fiber
          Rear Body Mount: 0.12" (3mm) thick carbon fiber
          Shocks: Four oil-filled, aluminum bodied with coil over spring
          Transmission: Stealth type, with adjustable slipper clutch, mounts
            in either rear or mid-motor configuration and is easily switchable
          Differential: Ball type with ceramic diff balls
          Battery Mount: Plastic cradle molded for six cells and Velcro straps
            to hold cells, multiple chassis mounting positions
          Caster: Adjustable front and rear, caster/toe-in refers to the angle
            of the front suspension when viewed from the side of the car in
            relation to the chassis
          Camber: Adjustable, camber refers to the angle of the tops of the
            tires from vertical when viewed from front or behind vehicle
          Steering: Sliding rack with adjustable Ackermann, Ackermann describes
            the effect of the inside front wheel turning faster than the
            outer front wheel during turns
          Spur Gear: 48 pitch 81 tooth composite construction

INCLUDES: Intimidator SE Racing Chassis Kit with shocks, small tube of diff
            grease, spur gear, and instruction manual

REQUIRES: Radio: 2-channel with one standard size servo
          AA Batteries: 8 for transmitter
          Motor: Brushless recommended, number of turn to be determined by
            modeler
          Pinion Gear: ASCC5258, 48 pitch to match spur gear, 21 tooth is
            good starting point for the above motor
          Electronic Speed Control: Compatible with number of turns of selected
            motor
          Battery: 2S LiPo recommended
          Battery Charger: For selected battery
          Body: 1/10 scale lightweight racing type CSWC9001, CSWC9017
          Building and track equipment

SPECS:    Dimensions are not provided. Contact manufacturer for further info.

COMMENTS: For Replacement Ball Bearings use:
              Qty.  Size      Location              Qty. Bearing Set
               1  5/32x5/16"  Diff Gear              1   DTXC1411
               1  5/32x5/16"  Outdrive Hub           1   DTXC1411
               2  3/8x5/8"    Trans Case             1   DTXC1437
               4  3/16x3/8"   Rear Hubs              2   DTXC1423
               2  3/16x3/8"   Transmission           2   DTXC1423

                                                                    jxs 6/06/12
                                                                         ir/jxs