This is in extremely powerful sail winch servo, with dual ball bearings and|
Hitec S type connector.
Connector is compatible with all modern receivers and wiring accessories
Indirect drive motor
Water tight case
Transit time .46 seconds/140°
Torque 231 oz-in
DIMENSIONS: 66x30x56.7mm, 2.59x1.18x2.23" (L,W,H)
Servo mounting screws, grommets, and eyelets
1 each of the following servo arms. Large wheel, large X, and large
1 sail arm, 122mm overall length, 110mm center of mount to outside
Special Y- harness for use with BEC receivers (see comments)
This servo consumes 800mAh UNLOADED, Hitec states that it REQUIRES
a minimum of 1200mA receiver battery, 6V (5 cell) is STRONGLY
If connecting to a BEC receiver, the Rx battery must be plugged in
to one side of the supplied Y harness, the servo into the other
side, and then connected to the receiver. IT WILL NOT WORK IF RUN
WITH A BEC RX CONNECTED IN ANY OTHER WAY!!!!!
Standard Rx's connect as normal
For Sail Arm, order HRCM6362.
For replacement Gear Set, order HRCM6350.
9-3-97 *8) JBR
UPDATE JMM 2/8/03