Multiplex Float Set MiniMag

Tower Stock# LXNXV4  •  Manufacturer Stock# M733069
Multiplex Float Set MiniMag (large view)
Notes from our tech department:
This is the Float Set for the Multiplex MiniMag


Allows the MiniMag to take off and land on water and snow
Can also be used on other models of similar size weighing no more
than 1.4lbs (650g)
Constructed of Elapor foam, white in color-see COMMENTS below


Two floats, undercarriage unit, steel rudder and tail wheel wires,
Depron water rudder, two red decal strips, mounting hardware and


Brushless motor set-up for added power required for water take-offs
Medium viscosity CA glue (GPMR6008) and Activator (GPMR6035)
Note, do not use styrofoam safe CA


Length: 18.9" (479mm)
Width: 2.6" (67mm)
Height: 2.5" (65mm)
Weight: 3.5oz (100g) including decals and all mounting hardware


These floats are NOT made of styrofoam and it is not possible to
glue the material using white or epoxy glue. Medium CA glue used
with an activator or hot-melt glues are the only methods of gluing
recommended by the manufacturer.

jxs 01/24/07

‐ Mailing Address ‐
‐ Additional Contact Information ‐