This is the radio controlled, electric powered
                       Dumas Taylorcraft Park Flyer Kit.

FEATURES: Construction: Hand selected laser cut balsa
          Vacuum molded cowl
          Rudder and Elevator Control: Wire pushrod
          Servo Placement: Mounted in rails on fuselage
          Landing Gear: 1/16" diameter wire front, tail wire skid
            requires bending

INCLUDES: All balsa, lightweight colored (blue and yellow) tissue covering
            two 1-3/4" (45mm) lightweight foam main wheels, tail wire skid,
            lightweight plastic tail wheel, CA hinges and all hardware to
            complete kit, instruction manual, two full-size plan sheets,
            acetate sheet for windows and vacuum molded cowl.

REQUIRES: GWS IPS (indoor power system) motor with "A" ratio gear drive
            GWSG2023
          3 channel radio system (minimum)
          2 micro servos
          5A ESC w/BEC GWSM2059
          2 cell 700mAh LiPo battery
          GWS 8x6 prop, GWSQ2017
          Building and field equipment

SPECS:    Length: 23-7/8" (606mm)
          Wingspan: 40" (1016mm)
          Wing Area: 272sq.in. (17.57 sq dm)
          Airfoil: Flat bottom
          Center of Gravity (CG): 1-7/8" (48mm) back from the leading edge
            of the wing
          Control Throws-
            Elevator, Up and Down: 3/4" (19mm)
            Rudder, Left and Right: 7/8" (22mm)

                                                                  kpm02/19/2007
                                                                         ir/jxs