This is the HPI Nitro Star T3.0 Engine for use
                      with the RTR Nitro RS4 3 Evo+

FEATURES: 1-piece black crankcase
          6.5mm Rotary Carb
          Non-ringed/ ABC-type engine
          Standard crankshaft
          Side exhaust
          Heatsink Head

INCLUDES: One assembled engine with glow plug
          One instruction manual and sticker sheet
          One air filter with instruction sheet
          Three zip ties
          One hex wrench

SPECS:    Height from crankcase bottom to top of cylinder head: 3.8" (96mm)
          Width including mounting tabs:                        1.57" (40mm)
          Width below mounting tabs:                         1.2"  (31mm)
          Width between mounting holes same side:            0.43" (11mm)
          Width between mounting holes opposite side:        1.2"  (31mm)
          Width of exhaust opening:                          0.87" (22mm)
          Height of exhaust opening:                         0.17" (4.2mm)
          Distance between muffler mounting holes            1.1"  (28mm)
          Crankshaft Thread Size: 1/4-28
          Bore x Stroke: 16.8 x 13.6mm
          Displacement: 0.18 cu in (3.01cc)
          Maximum Power: 2.2PS/31,000 RPM

REQUIRES  Fuel with 20%-25% Nitromethane and 18% (minimum) oil content

COMMENTS: The factory setting of the needle valves are as follows:
          High speed needle: Flush with the carburetor body
          Low Speed Needle: Flush with the carburetor body

                                                                    cnh 5/28/08
                                                                         ir/jxs