This is the Fuel Inlet for the Tower 61 and 75 Engines.
The inlet is located on the remote needle valve where
fuel comes from the tank and then goes to the carburetor.
FEATURES: Pre-assembled fuel inlet
Threaded end for assembly onto the remote needle
INCLUDES: One fuel inlet
Two pressure fittings (nipples) (TOWG4994)
Two small Red fiber washers
One large Red fiber washer
One 63mm silicone fuel tubing
REQUIRES: Assembly onto the remote needle valve
5mm nut driver to tighten pressure fittings
SPECS: Length: 16mm
Outer diameter: 9.8mm
COMMENTS: Pressure fittings are mounted at a right angle to each other.