HPI Racing Pro Glow Plug Ignitor w/AC Charger

Tower Stock# LXVZ07  •  Manufacturer Stock# 74108
HPI Racing Pro Glow Plug Ignitor w/AC Charger (large view)
Notes from our tech department:
This is a Glow Plug Igniter with Cap Meter and AC Charger from HPI Racing.
The glow starter is used to heat a glow plug while starting an engine.


Hot pink machined and knurled aluminum battery holder.
NiCd cell provides higher voltage under a load than an alkaline cell.
Meter has green area for charged and red area for must recharge.
Spring-loaded locking socket design.
Comes on a picture instruction header card.


One Glow Starter with Cap Volt Meter.
One Panasonic 1.2volt, 1300mAh sub-C size NiCd Battery
One AC Charger (United States Standard)


Charging of NiCd battery for ten hours before use.


Adaptor Input: AC 120V~60Hz 2W (United States Standard)
Adaptor Output: DC 1.25V at 170mA
Shaft Length: 2-1/4" (57mm)


Battery for this glow-starter can be replaced with another sub-C
type battery by unscrewing the battery holder.
dew 11/18/00

See Tower Catalog page 178.
Parts Compatibility
‐ Manufacturer's Web Page ‐
‐ Mailing Address ‐
‐ Additional Contact Information ‐