This is the Expanded Scale Voltmeter from Tower Hobbies.
      This is ONLY designed for testing NiCd and nickel-metal hydride
                     Transmitter and Receiver Batteries.
     It cannot be used to test capacity or voltage in glow plug NiCds or
                       other field batteries below 4V.

FEATURES: Load tests 4.8V receiver and 9.6V transmitter NiCd and nickel-metal
            hydride battery packs
          Simulated load on transmitter side is 250mA
          Simulated load on receiver side is 225 - 275mA
          Detects under-charged battery or bad cells in a pack
          Green = good, Red = recharge scale with bottom numbers representing
            receiver batteries and top numbers representing transmitter packs
          Two year limited warranty, U.S. and Canada only

INCLUDES: Expanded Scale Voltmeter with instruction sheet and test leads
            (included test leads are probe type and not specific to any
             battery)

REQUIRES: Leads depending on brand and type of radio;
            HCAP0101   TX/RX charge leads NO 9VAP Futaba J
            HCAP0102   TX/RX charge leads 9VAP only Futaba J
            HCAP0105   TX/RX charge leads JR
            HCAP0106   TX/RX charge leads Hitec/Airtronics Z
            HCAP0108   Two charge leads with alligator clips

          Modelers can make their own connectors by purchasing Banana Plugs
            (HCAP0310), 16 Gauge Wire, and their Radio Connector.

SPECS:    Dimensions: 4 x 2.9 x 1.5" (101 x 73 x 39mm)

COMMENTS: Diode protected transmitter batteries cannot be tested through the
            transmitter charge jack. The battery must be removed from the
            transmitter to get an accurate voltage reading.

                                                                   jxs 01/26/09
                                                                         ir/jxs