Tower Hobbies Laser 200 Flatty 3D EP ARF 33.5"

Tower Stock# L32101  •  Manufacturer Stock# TOWA2005
  • front/side (see larger view)
  • rear/side (see larger view)
  • top (see larger view)
  • bottom (see larger view)
  • out of package (see larger view)
Notes from our tech department:
This is the Radio Controlled, Electric Powered, Almost Ready to Fly
Laser 200 Flatty 3D Aerobatic Airplane from Tower Hobbies.
Designed by Team Futaba member and R/C legend Frank Noll.
For flying indoors in large areas such as basketball courts,
or outdoors only in very light wind conditions.
For intermediate to advanced pilots.

FEATURES

Construction: Depron flat sheet foam with factory applied trim scheme
Wing: One piece
Landing Gear: Wire with two 1.1" (29mm) diameter foam wheels
Building Time: Approximately 3 hours

INCLUDES

Laser 200 Flatty 3D Aerobatic Airplane with Landing Gear, Hardware
Package and Instruction Manual

REQUIREMENTS

Brushless Motor: Ountrunner type such as the Rimfire 250, GPMG4502
Electronic Speed Control: 8-10A
Radio: 4-channel with micro receiver, and three micro servos
(1-each ailerons, rudder and elevator)
LiPo Battery: 2S 7.4V at least 350mAh
Propeller: 8x3.8 Slo Flyer
Buyilding and field equipment

SPECIFICATIONS

Wingspan: 33.5" (850mm)
Length: 33" (840mm)
Wing Area: 261 sq in (16.8 sq dm)
Weight Range: 5.6 - 6.4oz (160 - 180g)
Wing Loading: 3.1 - 3.5oz/sq ft (9 - 11g/sq dm)
Center of Gravity (CG): Directly over main spar, or up to 3/8" (10mm)
ahead of spar, or up to 1/4" (6mm) behind spar
Control Throws Normal 3D
Elevator; 1" (25mm) 17 2" (51mm) 35
Rudder; 1-3/4" (44mm) 27 3" (76mm) 51
Ailerons; 1-1/2" (38mm) 24 2-1/2" (64mm) 42

jxs 03/30/15
ir/jxs

Resources
See Tower Catalog page 6.
Know Before You Fly
Easy RC: Airplanes
Review #2
Review #3
Review #4
‐ Mailing Address ‐
‐ Additional Contact Information ‐