Tower Hobbies Laser 200 Flatty 3D EP ARF 33.5"

Tower Stock# TOWA2005  •  Manufacturer Stock# TOWA2005
Tower Hobbies Laser 200 Flatty 3D EP ARF 33.5
Regularly Purchased Together
Although customers also purchased these, compatibility is not guaranteed. Click an item for product details.

Notes from our tech department:
This is the Radio Controlled, Electric Powered, Almost Ready to Fly
Laser 200 Flatty 3D Aerobatic Airplane from Tower Hobbies.
Designed by Team Futaba member and R/C legend Frank Noll.
For flying indoors in large areas such as basketball courts,
or outdoors only in very light wind conditions.
For intermediate to advanced pilots.

FEATURES

Construction: Depron flat sheet foam with factory applied trim scheme
Wing: One piece
Landing Gear: Wire with two 1.1" (29mm) diameter foam wheels
Building Time: Approximately 3 hours

INCLUDES

Laser 200 Flatty 3D Aerobatic Airplane with Landing Gear, Hardware
Package and Instruction Manual

REQUIREMENTS

Brushless Motor: Ountrunner type such as the Rimfire 250, GPMG4502
Electronic Speed Control: 8-10A
Radio: 4-channel with micro receiver, and three micro servos
(1-each ailerons, rudder and elevator)
LiPo Battery: 2S 7.4V at least 350mAh
Propeller: 8x3.8 Slo Flyer
Buyilding and field equipment

SPECIFICATIONS

Wingspan: 33.5" (850mm)
Length: 33" (840mm)
Wing Area: 261 sq in (16.8 sq dm)
Weight Range: 5.6 - 6.4oz (160 - 180g)
Wing Loading: 3.1 - 3.5oz/sq ft (9 - 11g/sq dm)
Center of Gravity (CG): Directly over main spar, or up to 3/8" (10mm)
ahead of spar, or up to 1/4" (6mm) behind spar
Control Throws Normal 3D
Elevator; 1" (25mm) 17 2" (51mm) 35
Rudder; 1-3/4" (44mm) 27 3" (76mm) 51
Ailerons; 1-1/2" (38mm) 24 2-1/2" (64mm) 42

jxs 03/30/15
ir/jxs

Resources
See Tower Catalog page 6.
Know Before You Fly
Easy RC: Airplanes
Review #2
Review #3
Review #4
‐ Mailing Address ‐
‐ Additional Contact Information ‐