This is the Tekin Mini Rage Electronic Speed Control
                         for 1/18 scale vehicles.

FEATURES:   ESC
          On-board programming
          Adjustable drag brake and reverse brake strength
          Programmable Reverse lockout and low voltage cutoff
          Adjustable throttle and Brake profiles (2 modes with 7 profiles each)
          Pre-installed Futaba J plug (JR and KO plugs also included)
          Pre-Installed ON/OFF switch
            Motor
          Three wire design with pre-installed 3.5mm bullet connectors
          Ball bearing-supported
          Sensorless and brushless 5.4kV with high performance bearings

INCLUDES: Tekin Mini Rage Speed Control
          Three 3" long leads with 3.5mm female bullet connectors installed
          Two 3.5" long leads (no connector, one black and one red wire)
          Four 1x1" pieces of double sided tape
          Two 2.5x5mm hex head motor mounting screws (requires 2mm hex wrench)
          Two black plastic radio connectors (JR and KO)
          Three sheets of Tekin logo decals (various colors included)

REQUIRES: Installation following the included intructions sheet, battery
           connectors of modeler's choice, soldering iron and solder

SPECS:      ESC
          Length: 1.72" (44mm)
          Width:  0.95" (24mm)
          Height: 0.4" (10mm)
          Weight: 0.9oz (24.5g)
          Power: 25A
          Surge: 60A
          Resistance: 0.0045
          Input power (except 8kV motor): 4-12 cells NiCd/NiMH or 2-4 cell LiPo
          Input power (8kV motor): 4-8 cell NiCd/NiMH or 2-3 cell LiPo
          Power Wires: 16AWG silicone
COMMENTS: Designed to work with a specific Tekin motor

                                                                    jxs 6/28/05
                                                                    update
                                                                  kpm10/31/2005
                                                                         ir/jxs