Phoenix Model Strega P-51 20cc-30cc GP/EP ARF 68.9"

Tower Stock# L33408  •  Manufacturer Stock# PH150
Phoenix Model Strega P-51 20cc-30cc GP/EP ARF 68.9
Notes from our tech department:
This is the Phoenix Model Radio Controlled 20-30cc Glow or Electric Powered
1/6 scale Almost Ready to Fly Strega Airplane.
For Intermediate Pilots.


Construction: Balsa and ply
Wing: Two-piece with aluminum joiner tube and recessed areas for
wheel wells
Cowl: Painted fiberglass
Covering: High quality heat shrink covering
Landing Gear: Retracts with CNC machined metal struts, spring tail
gear, plastic wheel wells in wing
Wheels: 3.25" (82.5mm) main, 1.5" (38mm) tailwheel
Spinner: Red plastic 3.7" (95mm) diameter
Top Hatch: Removes for easy access to battery and radio equipment
Engine Mount: Two-piece composite
Motor Mount: Plywood
Fuel Tank: Approximately 16oz (473cc)
Warranty Period: 90 day limited warranty


Prebuilt Wing, Fuselage and Tail Assemblies, Retracts, Main Wheels
Tailwheel, Spinner, Engine Mount, Motor Mount, Instruction Manual,
Fuel Tank, Decal Sheet


Gasoline Power;
Engine: 30cc
2-cycle oil, ignition battery

Electric Power;
Brushless Motor: Great Planes Rimfire 1.20 recommended
ESC: at least 80A if using the Rimfire 1.20 motor listed above
LiPo Battery: 5-6 cells, 5500 - 6000mAh
Charger, charging bag

Propeller: Compatible with selected engine or motor
Radio: 6-channel minimum
Servos: 7 standard size, high-torque, 2-aileron; 2-flap; 1-elevator
1-rudder; 1 throttle (if using gas engine)
Retract Gear Servos: Two, Futaba S3170G recommended
Receiver Battery: 4.8-6V / 2000mAh NiMH
Field and maintenance equipment


Length: 62.5" (1587mm)
Wingspan: 68.9" (1750mm)
Flying Weight: 11.9-13.2lbs (5400-6000g)
Wing Area: 1037 sq in (66.9 sq dm)
Wing Loading: 26.21oz/sq ft (80g/sq dm)
Wing Type: NACA airfoils
Servo Mount: 0.83 x 1.6" (21mm x 42mm)
Center of Gravity (CG): 6.1" (155mm) back from leading edge of wing
measured at the fuselage
Control Throws: Low Rate High Rate
Ailerons, up/down: 0.43" (11mm) 10% expo 0.51" (13mm) 10% expo
Elevator, up/down: 0.43" (11mm) 12% expo 0.51" (13mm) 12% expo
Rudder, right/left: 1.2" (30mm) 15% expo 1.6" (40mm) 15% expo
Flap, Mid 0.59" (15mm) down, Landing 0.79" (20mm) down


If a replacement fuel tank is needed the Sullivan 16oz (SULQ1443),
or the DuBro 16oz (DUBQ0216) can be used.
Some modification and trimming to the fuselage may be required when
installing any aftermarket tank.

jxs 04/14/16

Know Before You Fly
Easy RC: Airplanes
‐ Mailing Address ‐
‐ Additional Contact Information ‐