This is the radio controlled, glow or electric powered, almost ready to fly
SeaBee Sport/F3A Pattern Airplane from Phoenix Models.
For Intermediate to Advanced Modeler/Fliers.
**Additional Technical Info Will Be Added When It Becomes Available.**
FEATURES: Construction: Balsa and plywood
Wings: One-piece all wood
Aileron Control: Dual servo
Cowl: Painted fiberglass
Canopy: Clear plastic with painted pilot figure
Covering: Factory applied Oracover in a red and white trim scheme
with blue and yellow accents, black stars and black lettering
Radio Compartment: Easily accessible over wing, plywood reinforced
Spinner: 2.25" (57mm) red plastic
Landing Gear: Prebent aluminum 3/16" (4mm) thick with 0.078" (2mm)
diameter wire
Wheel Pants: Painted fiberglass
Wheels: Main, 2.2" (57mm) treaded rubber, tailwheel, 1" (25mm)
Warranty: 90 day limited warranty beginning at date of purchase
Building Time: Ready to fly in several hours
INCLUDES: Pre-built and covered wings, fuselage and tail assemblies, pushrods,
pre-bent main landing gear, tailwheel wire and wheel, main wheels
mounted aluminum non-adjustable engine mount, fuel tank, spinner
foam padding, pilot bust, wood servo trays and wing joiners,
hardware package, decal sheet and photo-illustrated instructions
REQUIRES: Radio: At least 4 channels
6" (152mm) Extensions: Two
Servos: 5-Standard (2-Aileron, 1-Elevator, 1-Throttle (if using glow
power) 1-Rudder)
Servo Extension 6": Two for aileron servos
Y-Harness: One for aileron servos
For Glow Power;
Engine: .46 (7.5cc) 2-stroke OR .52 (8.5cc) 4-stroke
Muffler: Sports-style supplied with engine, cowl requires trimming
to accomodate engine and muffler
Propeller: Depending on selected engine
Glow Fuel
For Electric Power;
Motor:
Propeller
SPECS: Wingspan: 55.1" (1400mm)
Length: 53.9" (1370mm)
Weight: 6.1lb (2780g)
Center of Gravity (CG): 4.3" (110mm) back from the leading edge of
the wing at the fuselage side
Airfoil: Fully-symmetrical, mid-wing placement
jxs 10/20/11
|