This is the glow powered Fun Star 3D .46 ARF by Phoenix Aircraft Models.
                    This is a Low Wing Aerobatic Airplane.
    Recommended for modelers who have had trainer airplane experience and
   have also flown/landed low wing trainers. This is a good 3rd or 4th ARF.

FEATURES: Construction: Balsa and plywood
          Wings: One-piece, pre-covered
          Covering: Heat-shrink Oracover film covering, color scheme is
            transparent Orange with solid Red cowl and front of fuselage
          Canopy: Single, clear
          Cowl: Pre-painted fiberglass, must be cut to accomodate engine and
            muffler
          Cockpit features: Dark Blue with Red pilot bust
          Landing gear: Pre-bent wire 3/16" (4mm) diameter, with 2.4" (61mm)_
            rubber treaded wheels
            1" (25mm) tailwheel with pre-bent 0.078" (2mm) diameter wire
          Hardware: Complete package including all fasteners and hinges
          Motor Mount: Installed, aluminum, non-adjustable

INCLUDES: Decals; complete hardware package including wheels, engine mount,
            landing gear, pushrods, nuts, and bolts; prebuilt wings, fiberglass
            cowl, clear canopy, foam rubber, photo-illustrated instructions,
            and fuel tank

REQUIRES: Engine:  .40-.46 cu in (6.5-7.5cc) 2-stroke
              OR   .48-.53 cu in (7.8-8.7cc) 4-stroke
          Muffler: Stock type supplied with engine
          Propeller: 10x6-12x7
          Spinner: 2-1/4" (57mm)
          Radio:   4 channel
          Servos:  5 standard size and torque
          Y-Harness: One for aileron servos
          Servo Extensions: Two 6" (152mm) for aileron servos, and two 6"
            (152mm) for rudder and elevator servos

SPECS:    Wingspan:     52.7" (1340mm)
          Wing area: 817 sq. in. (approx.)
          Weight:        4.4lbs (2000g) approximately
          Length:       51.5" (1310mm)
          Airfoil: Fully-symmetrical low wing
          Center of Gravity: 3.9"-4.7" (100-120mm) Back from the wing's
            leading edge at the fuselage sides.
          Control Throws-
            Ailerons: Up & Down   0.79" (20mm)
            Elevator: Up & Down   0.98" (25mm)
            Rudder: Right & Left   2.0" (51mm)
          Incidence-
            Engine Right Thrust: 2°
             Engine Down Thrust: 2°

COMMENTS: The pictures on the box and in the manual show crossbars in the
            wing flaps, however the crossbars are NOT included in the actual
            kit.
          The pilot shown inside the plane is included.

                                                                    EEW 7/29/03
                                                                         ir/jxs
                                                               updt jxs 9/22/03