Instruction Manuals:	Manual 1 (409 KB)
Tower Catalog Page:	209
E-mail This Page To A Friend

   Put an end to recoil starter headaches and add one-hand starting ease by
    installing the Kwik-Pit Super Start System from DuraTrax on your model.
            This version will convert recoil equipped DuraTrax Brand
                            .18 Engine - DTXG0225.

FEATURES: Easy one-hand starting means the end of blisters and broken recoil
           ropes
          Powerful twin 540 motors are powered by twin 6-cell sub-C stick
           battery packs (not included) Unit will not operate on only one pack
          Steel gear drive
          Dust and impact resistant composite plastic case
          Hinged access door provides for easy battery installation
          ON/OFF rocker switch with safety side guards
          Twin ball bearing supported gear drive
          Two clips on the unit's bottom for storage of starting shaft

INCLUDES: One Kwik-Pit Super Start power unit
          One front and rear gear case - key number 24 (DTXP6060)
          One 32 tooth steel, adapter gear - key number 18 (DTXP6051)
          One 11 tooth steel, small adapter gear - key number 12 (DTXP6045)
          Four 2.6x10mm hex head screws - key number 25 (DTXQ0283) (requires a
           2mm allen wrench for installation - DTXR0252)

REQUIRES: The stock engine back plate and one way bearing (the one-way bearing
           can be difficult to remove, for a replacement bearing order DTXG0537
          Two 6-cell sub-C batteries and charger - DTXP4600 or modeler's choice
          Installation following included instructions sheet

                         Starting Unit            Starting Shaft
SPECS:    Length:         10" (254mm)               7.25" (185mm)
          Width:          2.1" (53mm)                 NA
          Height:         4" (101mm)_                 NA
          Diameter:         NA                      .21" (5.4mm)

COMMENTS: A substitute for this item would be the Super Start for the OS
            .12-.21 engines (DTXP6020)-also the OS #5 One-Way Bearing
            (OSMG8980) MUST be purchased when using the DTXP6020 with DuraTrax
            engines.
                                                                  kpm01/20/2005
                                                                         ir/jxs



– If you need more information, use these DuraTrax resources –

Click Here: Manufacturer's Product Web Page
E-mail: carsupport@duratrax.com
Web Site: http://www.duratrax.com/
Phone: 217-398-8970


 
Postal Address:
DuraTrax
3002 N. APOLLO DRIVE, SUITE #1
CHAMPAIGN, IL 61822  








Click here for Units of Measure Conversion Calculators