Tower Hobbies TS-80 2BB Giant Scale Servo U

Tower Stock# LXLN94  •  Manufacturer Stock# TOWM5210
Tower Hobbies TS-80 2BB Giant Scale Servo U (large view)
Notes from our tech department:
This is a Giant Scale Servo by Tower Hobbies.
This Servo is Used for Very Large Scale Cars, Trucks or Airplanes
Where A Large Amount of Torque is Necessary.


One of the Strongest Servos Available Anywhere
Dual Ball Bearings for Smooth Output and Precision
Watertight Case
Indirect-Drive Potentiometer
Enormous Gear Train for Reliable Operation
Universal Connector Fits Futaba, Hitec, JR, KO Propo, Airtronics Z
and Tower Hobbies.
One Year Warranty


One Giant Scale Servo w/Universal Connector
Three Extra Heavy Output Arms
One Hardware Accessory Bag (Screws, Grommets, Eyelets)
One Universal Y-Harness (See COMMENTS)


4.8V (4 cells) 6.0V (5 cells)
Torque: 275 oz-in (19.8 kg-cm) 343 oz-in (24.7 kg-cm)
Speed: 0.19 sec/60 0.14 sec/60
Current Drain: Idle: 8mA
Running w/No Load: 700mA
Signal Pulse: Positive Pulse Control 1520us Neutral
Weight: 5.4oz (153g)
Length: 2.6" (66mm)
Width: 1.2" (30mm)
Height: 2.3" (58mm)


Universal Y-Harness: Because This Servo has a High Current Drain, the
Y-Harness is Used to Plug the Servo Into the Receiver and Also to
Wire Directly to the Battery Pack for A Power Sorce. This is Done
so the High Current Does Not Damage the Receiver. It is Up To The
Modeler to Hook Up the Power Supply Wire to the Battery.

JAL 2/4/99
updated jpg 3/18/08

See Tower Catalog page 162.
Parts Compatibility
‐ Mailing Address ‐
‐ Additional Contact Information ‐