SuperTigre G-34 Dual BB Ringed Control Line w/Muffler

Tower Stock# LXMRB6  •  Manufacturer Stock# 11004299
SuperTigre G-34 Dual BB Ringed Control Line w/Muffler (large view)
Notes from our tech department:
This is the SuperTigre G-34 Ring Control Line Engine with Muffler.


Control line engines replace the carburetor with a venturi that
keeps the engine running at a constant speed
Schnuerle porting, dual ball bearings and friction reducing cylinder
Three year limited warranty


Supertigre G-34 Ring Control Line Engine with Muffler, header with
gasket, glow plug, venturi, pressure fitting and
illustrated instruction manual


Car fuel with 0-15% nitro content and 18-20% lubricant
Propeller: 8x7, 9x6, 9x7, 10x5
Glow starter and field equipment


Displacement: .34 cu in (5.5cc)
Bore x Stroke: .787x.669" (20x17.5mm)
Output: BHP/RPM .98 @ 16,500
Weight with Muffler: 12.73oz (363g)

Distance between mounting holes same side: .59" (11mm)
Distance between mounting holes opposite side: 1.5" (38mm)
Height from crankcase bottom to top of cylinder head: 2.99" (76mm)
Height from bottom of mounting tab/top of cylinder head: 2.40" (61mm)
Crankcase width below mounting tabs: 1.18" (30mm)
Distance from rear cover plate screw/front bearing: 2.87" (73mm)
Distance from center of piston to front bearing: 2.13" (54mm)
Crankshaft size: 1/4-28
Carb Settings: H-2-turns out from closed position.
L- Take carb off, rotate and look at bottom side.
Turn trottle until wide open, set tip of low end
needle half-way across cat eye.

jxs 7/11/06
updt lmm 3/26/09

‐ Manufacturer's Web Page ‐
‐ Mailing Address ‐
‐ Additional Contact Information ‐