This is a Digital Voltmeter MkIII from Hobbico.|
Tests 4, 5 & 8 cell R/C batteries in a no-load or a simulated R/C load setting.
Custom designed LCD shows voltage in clear ½" numerals, plus
customized characters to easily determine the meter setting and
condition of the battery under test. The LCD not only displays
voltage, but voltage mode, "OK" and "RECHARGE".
Test 5 cell packs, in addition to 4- and 8-cell batteries.
Includes a common 9V battery, located inside an easy-to-access
Built-in simulated R/C load of 250mA for each setting
Includes two input controls: a small pushbutton on the left side of
the case, and a 3-position slide switch on the face of the meter.
Switch load OFF and use it as a true Digital Voltmeter
Measures DC voltage up to 19.99V, making it versatile enough for any
DC battery - transmitter/receiver packs, starter batteries, and
glow starter batteries.
A 10 minute auto-timer shuts the unit OFF automatically if left ON
by accident, to help prevent unwanted battery drain.
Rubber grip for no-slip handling
Color coded banana jacks, compatible with most common test leads
One year limited warranty
One Digital Voltmeter MkIII with pre-installed 9V battery
One Instruction Sheet
Test or charge leads with banana plugs such as the Hobbico
pre-assembled test and charge leads (HCAP0101 HCAP0110)
TACP0101 FUTABA J Tx/Rx CHARGE LEADS (NOT FOR 9VAP)
TACP0102 FUTABA J Tx/Rx CHARGE LEADS 9VAP ONLY
TACP0105 JR Tx/Rx CHARGE LEADS
TACP0106 HITEC/AIRTRONICS Z Tx/Rx CHARGE LEADS
TACP0107 CHARGE LEAD GLOW-STARTER - ALL
TACP0108 CHARGE LEAD W/ ALLIGATOR CLIP(2)
TACP0109 VOLTMETER TEST PROBES (2)
TACP0110 CHARGE LEADS 9V Tx PLUG and FUT J Rx
The modeler may purchase the preceding pre-made Rx and Tx connectors:
_ However, you CANNOT test diode-protected Tx packs with voltmeters
through the radio charge jack. The pack MUST BE REMOVED from the
transmitter to get an accurate voltage reading.
Modelers can make their own connectors by purchasing one HCAP0310
Banana Plugs, 16 Gauge Wire, and their radio connector
Supply voltage: 9V DC
Input test settings under load: 4.8V DC (4 cell battery)
6V DC (5 cell battery)
9.6V DC (8 cell battery)
Optional load current: 250mA each setting
Maximum voltage measurement: 19.99V DC
Length: 4.5" (113mm)
Width: 2¾" (67mm)
Height: 1" (25.4mm)
Weight: 4.7oz (136g)
Auto-off timer: Shuts OFF after 10 minutes
Low battery indicator: Battery symbol in LCD window
updt jxs 3/13/03