This is the Novak M2 Dig 3S Electronic Speed Control
                  and two Terra Claw 55 Turn Brushed Motors.

FEATURES:   M2 Dig 3S ESC;
          Independently powers the front or rear motors in a dual-motor
            crawler, applicable for dual brushed motor or single brushed
            motor applications
          Compatible with any Super Crawler dual-system rig, such as EnRoute's
            Berg, Team Integy's Super and Unlimited class of crawlers and
            Clod Buster based vehicles
          Five adjustable parameters; Drag Brake, Dead Band, Minimum Drive,
            Drive Frequency and Battery Selection (LiPo LiFe and NiMH)
          Can be adjusted and fine tuned via Novak's PC interface, the Novalink
            not included
          Compatible with dual-brushed motor or single-brushed motor
            applications
          Universal JST Input Plug fits all popular brand receivers
          Water-resistant case with gasket seal
            Terra Claw 55 Turn Brushed Motor;
          High-strength ferrite magnet
          Precise movement control and exceptional torque and long-run times
            due to the high turn count
          0.125" (3.2mm) shaft diameter fits all common pinion gears
          120 day limited warranty on both components through Novak

INCLUDES: Novak M2 Dig 3S Electronic Speed Control with receiver plug, power
            wires, two Terra Claw 55 Turn Brushed Motors and instruction sheet

REQUIRES: Installing in vehicle and connecting to battery and receiver

SPECS:      M2 Dig 3S ESC
          Input Voltage: 2-3S LiPo/LiFe cells or 4-9 NiMH cells (1.2V/cell)
          On-Resistance (dual motor): 0.0016 ohm at 25° C trans temp
          On-Resistance (single motor): 0.0008 ohm at 25° C trans temp
          Size: 1.16 x 1.47" (29.5 x 37.3mm)
          Weight (w/o wires): 1.30oz (36.9g)
          Motor Limit: 27-turn (2S), 33-turn (3S) 540-sized dual brushed motors
          BEC: 6.0 volts DC/5.0 amps
          Status LEDs: 4 on-board; 2 external
          Voltage Cut-Off: 6.25V (2S LiPo), 4.75V (2S LiFe), 9.75V (3S LiPo)
            7.125V (3S LiFe) (when LiPoly cut-off circuitry is enabled)
          Power Wires: 14G super-flex copper-strand silicone wire
            Terra Claw 55 Turn Brushed Motor
          Size: 2.07 x 1.42" (52.7 x 36.1mm)
          Shaft Diameter: 0.125" (3.2mm)
          Motor Weight: 5.97oz (169g)
          Input Voltage: 4-7 cells (1.2V/cell) or 2-35 LiPo/LiFe cells
          Bearing: Standard, 3/8 x 1/8"
          Magnet: High-strength ferrite
          Number of Turns: 55

                                                                   jxs 12/10/10
                                                                         ir/jxs